Quiz - VARIABLE SPEED DRIVES VLB3 Series

1. Final quiz.

In this section, test your knowledge of the e-learning course you have just followed. Are you ready? Then start and don't worry about making mistakes, repeat the test as many times as you want.

Question Title

1. Group 3 is dedicated to the setup of the motor parameters: the selection of the motor control mode and its nameplate data. (Required.)

False

True

Question Title

2. In the parameters, Group 2 is one of the most important because it contains the main functions for programming the VSD ( choice of the start / stop command source, definition of the frequency regulation source, etc.).

(Required.)

False

True

Question Title

3. The READY LED on the drive changes from flashing to fixed when (Required.)

the drive is reset

the drive is reset to default

the drive is started

the drive is switched off

Question Title

4. To set default parameters you have to use: (Required.)

P600.01

P700.01

P500.01

Question Title

5. The function of the inputs can be changed at any time using the programming unit. (Required.)

False

True

Question Title

6. Default configuration of digital input DI1 controls: (Required.)

the invert rotation

the reset fault

the starting and stopping of the motor

Quiz - VARIABLE SPEED DRIVES VLB3 Series

1. Final quiz.

Question Title

* 1. Group 3 is dedicated to the setup of the motor parameters: the selection of the motor control mode and its nameplate data. (Required.)

Question Title

* 2. In the parameters, Group 2 is one of the most important because it contains the main functions for programming the VSD ( choice of the start / stop command source, definition of the frequency regulation source, etc.). (Required.)

Question Title

* 3. The READY LED on the drive changes from flashing to fixed when (Required.)

Question Title

* 4. To set default parameters you have to use: (Required.)

Question Title

* 5. The function of the inputs can be changed at any time using the programming unit. (Required.)

Question Title

* 6. Default configuration of digital input DI1 controls: (Required.)

1. Group 3 is dedicated to the setup of the motor parameters: the selection of the motor control mode and its nameplate data. (Required.)

2. In the parameters, Group 2 is one of the most important because it contains the main functions for programming the VSD ( choice of the start / stop command source, definition of the frequency regulation source, etc.).

(Required.)

3. The READY LED on the drive changes from flashing to fixed when (Required.)

4. To set default parameters you have to use: (Required.)

5. The function of the inputs can be changed at any time using the programming unit. (Required.)

6. Default configuration of digital input DI1 controls: (Required.)